JBR 2010-2013 Mazdaspeed 3 Power Path Stage III Cold Air Intake

Description

Details:

The JBR Power Path Stage III Cold Air Intake kit is a complete replacement for the restrictive factory air filter box and turbo inlet pipe. Plus, it includes an additional section of tubing that allows the intake to draw cool air from the inner fender well of your MAZDASPEED 3. The Stage III kit includes the JBR Power Path SRI, Turbo Inlet Pipe and Cold Air piping kit. Simple to install and no ECU tuning is required. Peak Performance and value all in one kit!

The JBR Power Path Stage III Cold Air kit is capable if reducing intake air temperatures up to 15 degrees by drawing cool, fresh, oxygen rich air from deep inside the fender well area, far away from the heat of the engine. The Stage III Cold Air Kit has produced power and torque increases by as much as 14%! Add the JBR Cold Air Intake to your JBR SRI in the summer months when performance from heat suffers the most and remove it in when the weather is cooler and temperature conditions are ideal for making big power.

The JBR Cold Air Intake System is constructed out of smooth, mandrel bent, 6061 polished aluminum for maximum air flow. The kit also includes a custom, 4-ply polyester reinforced hi-temperature silicone elbow, Stainless Steel T-Bolt Clamps and all the necessary mounting hardware to perform the installation.

Every MAF housing is machined from a 6061 aluminum blank to tolerances of +/-.001′ and includes a factory style air straightener for the most accurate signal to the MAF sensor. Our MAF housings are the lightest in the industry weighing in at only 9.6oz. The lighter housing significantly reduces heat soak, sheds heat quicker lowering intake temperatures and creates more power. Each MAF housing is beautifully anodized for a smooth, long lasting finish resistant to corrosion, even when subjected to the harshest environmental conditions.

Our custom 5 ply polyester and wire reinforced silicone intake hose eliminates the turbulence caused by the factory hose. The JBR Turbo Inlet pipe, also 5 ply polyester and wire reinforced, is designed to replace the restrictive factory inlet pipe with no required modification to the vehicle. Its large cross-sectional design and smooth transition down to the turbo and allow for efficient flow air directly in to your turbo. Our silicone is installed using wide stainless T-bolt clamps, not weak worm gear clamps to ensure a leak free seal.

Every Power Path Short Ram Intake includes a Dry-Flow air filter. JBR Dry Flow air filters flow 200% more air than the factory filter while providing superior engine protection. It uses both depth loading, capable of removing extremely fine particles (down to < 0.1 micron), and structural screen wire to enhance airflow capabilities. This design results in a performance air filter capable of increasing horsepower and torque! The three-dimensional synthetic filtering medium is washable and requires no oiling for years of trouble free service.

The JBR Power Path Short Ram Stage III Intake kit carries our lifetime warranty and NO CEL guarantee.

Includes:

Precision Machined MAF Housing
Reinforced Hi-Temperature Silicone Intake Hose
Reinforced Hi-Temperature Silicone Turbo Inlet Pipe
Polished Aluminum Cold Air Pipe
Reinforced Hi-Temperature Silicone Elbow
Cold Air Kit Mounting Hardware
Stainless Steel T-Bolt Clamps
DRY Flow Air Filter
No CEL Guarantee
Installation instructions are available in our support section
Shipping is free in the US & our Hassle Free Lifetime Warranty is included